Publicité
area" or „Measuring volume". The surface
area/volume appears in the bottom line of
the display.
P ress the RECALL button
ured result. The symbol M+ appears in the
display and this indicates that the measured
result, which is shown at the bottom of the
display, is saved in the device
P ress the MODE button
vice is now ready to measure the next surface
area or volume.
M easure the next surface area or volume in
the same way as you performed the first
measurement.
N ow press the RECALL button again to adopt
the new result into the aggregate memory.
The result of the addition is shown in the
bottom line of the display.
I f you would like to add further surface areas
or volumes, repeat steps 3 to 5.
H old the MODE button pressed down for
3 seconds in order to leave the Addition
mode.
Displaying the last
measured values
A fter you have measured a surface area or a
volume, press the READ button
in order to display the individual values of the
measurement.
The symbol of the corresponding measured
value flashes, and the measured result is
shown in the top line of the display.
to save the meas-
5
.
10
briefly. The de-
8
repeatedly
4
GB/IE
15
Publicité
