Aventics RTC-CG Instructions De Montage page 13

AVENTICS | RTC-CG and HD | R402005942–BDL–001–AB | English
Parts kit for the clamping plate
The intermediate stop must be installed using an
adjustment plate on a clamping plate in order to align and
secure it. The intermediate stop is mounted either with the
clamping plate directly on a surface (table installation) or
"floating" on a strut profile at the desired intermediate-
stop position.
1 M6 screws
2 Adjustment plate
Parts kit for the intermediate stop
The RTC-CG or RTC-HD series rodless cylinders can be
equipped with intermediate stops in order to provide
multiple defined intermediate positions for the slide and
its components.
2
1
1 Body 3 Detent (as delivered)
2 M4 screws 4 Centering rings
1
3 T-groove nuts
4 Clamping plate
4
Parts kit for 15X120 profile (optional)
Using a strut profile, the intermediate stop with the
clamping plate installed can be float-mounted on the
rodless cylinder.
1
2
3
2
3
4
3
4
1 M6 screws
2 Clamping piece
3 T-groove nuts
5 Effective Direction of
Intermediate Stop
Please note the top side of the intermediate stop!
The top side determines the installation position. The
orientation of the detent determines the effective
direction.
O Do not install the intermediate stop upside down.
Left
3
The intermediate stop only functions in one slide travel
direction – left or right. The detent can be rotated by
means of a modification, which thus changes the effective
direction for the same installation position.
5
4 Covers
5 Strut profile
NOTICE
Right
3
4