Publicité
j
Then measure the second object. The LCD display
shows the deviation of the measurement of the second object
to that of the reference object (A).
Measuring the thickness of the floor of an object
(see fig. E):
j
First measure the depth of the object.
j
Leave the depth blade
to obtain the zero position (ZERO)
j
Now measure the entire object. The LCD display
shows the thickness of the floor of the object.
Measuring the distance between two identical
holes (see fig. F):
j
First measure one of the two, equally sized holes.
j
Leave the measuring jaws
the key to obtain the zero position (ZERO)
j
Now measure the total dimension. The LCD display
shows the average distance.
Characteristics of metric ISO screw threads:
Nominal diameter:
[mm]
3
4
5
6
8
10
12
16
20
Troubleshooting
Q
The device contains sensitive electronic components. That is why
it experiences interference when in close proximity to radio
transmission devices. If any indication errors appear in the
display, remove such devices out of the proximity of the calliper.
Electrostatic discharge could result in malfunctions.
j
When such malfunctions occur, remove the battery for a
short while and re-insert.
Failure
Five digits flash
simultaneously
every second.
in this position and press the key
6
2
Increase:
Core diameter:
[mm
]
[mm]
-1
0.5
2.46
0.7
3.24
0.8
4.13
1
4.92
1.25
6.65
1.5
8.38
1.75
10.11
2
13.84
2.5
17.29
Cause
The battery voltage
is lower than 2.7 V.
.
9
/
in this position and press
11
Solution
Replace the battery
in line with the chap-
ter on "Inserting /
replacing battery".
now
5
now
5
.
9
now
5
Drill
diameter:
[mm]
2.5
3.3
4.2
5
6.8
8.5
10.2
14
17.5
GB/IE/NI 11
Publicité
