Siebert S202 Série Manuel D'utilisation page 25

Monitor display
The monitor display in normal mode corresponds to the main display. It allows
reading the display values on the back of the units. In menu mode the display
represents a menu for the unit parameterization (see 'Parameterization').
Signal input
The units must be parameterized before they can be controlled. Parameterization
occurs in a menu (see 'Parameterization').
The units can be controlled with the normalized signals 0...20 mA, 4...20 mA,
0... 10 V and 2...10 V. In menu item 1 the input signals with which control is to be
carried out are set.
The power supply as well as the analog inputs are galvanically isolated from the
internal signal processing.
Display range
Start and end value of the display area can be set in the menu items 2 and 3.
The number of the menu item and the current setting appear in turns under menu
item 2 (start value) and 3 (end value) in the monitor display (menu item flashing). At
the same time, the decimal points flash in turns. The digit in which the decimal point
flashes can be set to the desired value by using the menu button [ ]. The minus sign
can be set in the left digit. It appears between 9 and 0.
o (overflow) will be indicated in case of a display overrange and u (underflow) in
case of a display underrange.
Step size
To be able to clearly read off the lowest digit even if the measurement signals are
changing rapidly or with large scale values, the step size can be augmented in menu
item 4.
With setting 5, digit C1 still only displays the digits 0 and 5. With setting 10, it displays
an unchanging zero.
With setting 50, digit C1 displays an unchanging zero, and digit C2 still only displays
the digits 0 and 5. With setting 100, digits C2 and C1 display an unchanging zero.
BAL S202 ANA M 1.0 25