Publicité
IV. GETTING STARTED
WARNING!
Before any intervention on product, ensure that power is set to the "OFF" position and
remove the battery pack.
4.1- Unpacking
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
4.2- Charging the battery pack
• Place the charger on a flat, dry surface within 1 meter of a wall socket.
• Remove the battery from the tool by pressing the battery release button and sliding the
battery out.
• Insert the battery pack into the charger and plug the charger into the wall socket.
• The red indicator light will turn on, showing that charging has begun.
• A green light will indicate that charging is complete.
• After charging, press the battery release button and slide the battery out of the charger.
Then, open the battery compartment cover (5) and reinstall the battery into the power tool.
• Unplug the charger from the mains.
• NOTE: Keep both the charger and battery at an ambient temperature between +10°C and
+40°C.
4.3- Filling the tank (3)
• Ensure the battery is removed before filling the tank.
• Place the sprayer on flat, level ground before beginning
the filling process.
• Remove the tank cap (2).
• Prepare the spraying chemical and ensure it is at
ambient temperature (between 5°C and 35°C).
• Pour the chemical into the tank through the tank filter.
• CAUTION! Transfer chemicals carefully to prevent
spills and environmental contamination. Clean up any
spills immediately.
• Do not exceed the maximum fill level (approximately
16 liters).
• Replace the tank cap after filling.
• Clean the exterior of the sprayer.
• WARNING! Do not mix chemicals directly in the tank. Pre-mix
and/or dilute chemicals in appropriate containers according to the
chemical supplier's instructions.
•
WARNING! Do not use flammable liquids or wet powders in this
sprayer.
4.4- Switch On/Off the pump
• Insert the fully charged battery pack into the battery compartment.
• The power switch is a rocker switch with three positions:
-
I: The pump operates at 3 bar
-
0: Power off
-
II: The pump operates at a pressure between 0 and 3 bar
• Set the power switch to position I or II to activate the pump.
• To switch off the pump, set the power switch to position 0.
Fig. 2
Fig. 3
Page 14 / 28
Publicité
