Publicité
3.1- General safety warnings
• Understand the product. Read and follow the instructions in this manual.
• Do not disassemble or modify the product.
• Ensure the product is fully assembled and that no parts are missing or damaged before use.
• Use and store the product in a dry environment.
• Maintain a good housekeeping and well-lit working area.
• Keep children and bystanders away while operating the product.
• Do not allow children to perform cleaning and maintenance tasks.
• Use only the attachments and accessories specified by the manufacturer.
• Service maintenance should be performed only by qualified personnel.
3.2- Additional safety rules for electric power tool
Electric power tool
• When the tool is not in use or before performing cleaning, turn it off and disconnect from
main power source.
• Never leave the product running unattended.
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
• Maintain labels and rating plate through the life of service.
• Do not use the power tool if the switch is unresponsive or does not turn on and off properly.
A tool that cannot be controlled with its switch is unsafe and should be repaired.
• Avoid using the power tool if you are tired or under the influence of drugs, alcohol, or
medication.
• Store unused power tools out of reach of children and ensure that only individuals familiar
with the tool and its instructions are allowed to operate it.
• If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or a qualified technician to prevent any hazards.
• Remove any adjusting key or wrench before powering on the tool.
• Keep handles and grasping surfaces dry, clean and free from oil and grease.
Battery charger
• The charger is designed for indoor use only.
• Do not abuse the power cord. Never use the cord for carrying, pulling or unplugging the
charger. Keep cord away from heat, oil, sharp edges or moving parts.
• Keep the charger away from water and moisture.
• Do not place objects on top of the charger or on surfaces that might obstruct the ventilation
slots, as this could cause excessive internal heat. Position the charger away from heat
sources.
• Do not disassemble charger. If service or repair is needed, take it to an authorized service
center. Incorrect reassembly may pose a risk of electric shock or fire.
• Charge the battery in an ambient temperature range of +4°C to +40°C.
WARNING! Electric hazard.
Disconnect from power source before cleaning, maintenance or any
intervention on the product.
Do not expose to weather conditions such as storms, rain, or snow.
Avoid using in damp or wet areas.
Page 12 / 28
Publicité
