Electrolux EES47311L Notice D'utilisation page 25

Problem and alarm code
Rattling or knocking sounds from
the inside of the appliance.
The appliance trips the circuit-beak‐
er.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
WARNING!
We do not recommend using the
appliance until the problem has been
completely fixed. Unplug the appliance
and do not plug it in again until you are
certain that it operates correctly.
12.1 Product number code (PNC)
When contacting an Authorised Service
Centre, provide PNC. PNC can be found on
the rating plate or displayed.
12.2 Dishwashing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
Possible cause and solution
• The tableware is not properly arranged in the baskets. Refer to basket
loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the applian‐
ces in use. Check the socket amperage and the capacity of the meter
or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Service
Centre.
Possible cause and solution
• Refer to chapters "Daily use", " Hints and tips" and to the basket loading leaflet.
• Use more intensive washing programme.
• Activate the option ExtraPower to improve the washing results of a selected pro‐
gramme.
• Clean spray arm jets and filters. Refer to the "Care and cleaning" chapter.
• Tableware was left for too long inside the closed appliance. Activate AirDry to set
the automatic opening of the door and to improve the drying performance.
• There is no rinse aid or the dosage is not sufficient. Fill the rinse aid dispenser or
set the dosage to a higher level.
• The quality of the rinse aid can be the cause.
• Always use rinse aid, even with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase. Refer to the programme table.
Before displaying PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously
for about 3 seconds.
The display shows PNC.
2. To exit, press and hold simultaneously
and for about 3 seconds.
The appliance returns to the programme
selection.
and
ENGLISH 25