Publicité
GETTING STARTED GUIDE
OVERVIEW
The Dicer is a unique controller for Serato's Scratch Live DJ software and provides DJs with tactile controls for
hot cues, loops and other functions. With 5 pads and 6 operating modes, each Dicer can control up to 30
functions in a pocket-size controller that fits neatly into your DJ setup. The unit comes ready to mount into any
Technics 1200/1210 turntable, or can be used with other decks and CDJs. Two Dicers can be daisy chained for
independent control of Decks A and B.
This 'Getting Started Guide' will help you set up your Dicers with Serato's Scratch Live software. We will assume
that you are familiar with Scratch Live, and that your computer meets its system requirements. Please visit the
Serato website at http://www.serato.com for further information on Scratch Live.
SETUP
By using two Dicers, each deck has independent
access to cues, loops and other functions.
1.
Using the micro USB cable provided,
connect the Dicer installed on Deck A
(the left deck) to the USB port of your
computer
2.
Using the 1/8”" TRS jack cable provided,
link the two Dicers together
3.
Start the Scratch Live software
The dual Dicer configuration is automatically
detected by Scratch Live. If all your connections
are correct, then each Dicer will operate the cues,
loops and other functions described on the next
page.
NOTE: The Dicer connected to your computer, via
USB,
always
controls Deck A (the left deck). The
Dicer connected via the stereo jack cable
controls Deck B (the right deck).
This 'Getting Started Guide' assumes that you are familiar with Scratch Live. So, before you go any further, make
sure that you have a track loaded to each deck you wish to control, and that the track is playing. Within the
Scratch Live software window you will see Deck A (on the left) and Deck B (on the right):
Page 4
All manuals and user guides at all-guides.com
always
DICER Getting Started Guide V1.0
Publicité
