Publicité
What to do if...
Problem
You cannot activate the appliance
or operate it.
A Sound operates and the appli-
ance deactivates.
A sound operates when the appli-
ance is deactivated.
The appliance deactivates.
The residual heat indicator does not
comes on.
The Automatic Heat Up function
does not operate.
The heat setting changes between
two levels.
The sensor fields become hot.
comes on
comes on
and number comes on.
22
All manuals and user guides at all-guides.com
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one
sensor field.
• The Child Safety Device or the Lock or Stop+Go operates. See the
chapter Operating instruction.
• There is water or fat stains on the control panel. Clean the control pan-
el.
You put something on one or more sensor fields. Remove the object from
the sensor fields.
You put something on the
The cooking zone is not hot because it operated only for a short time. If
the cooking zone should be hot, speak to the service centre.
• There is still residual heat on the cooking zone. Let the cooking zone
become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same
power as the Automatic Heat Up function.
The Power management is activated. See the section Power manage-
ment.
The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and activate
it again.
• No cookware on the cooking zone. Put cookware on the cooking zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for the cooking
zone. Move cookware to a smaller cooking zone.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Discon-
nect the fuse from the electrical system of the house. Connect again. If
comes on again, speak to the service centre.
Possible cause and remedy
. remove object from the sensor field.
Publicité
