Jacuzzi J.Touch Utilisation & Entretien page 42

Sanitization does not start
1
The Sanitization cycle
stops of its own accord
1
Additional error messages
(only with AQS models)
1 2
A
B
lack of electric energy
command not accepted
insufficient water level
lack of liquid sanitiser
lack of electric energy
insufficient water level
insufficient liquid sanitiser
data transmission system fault
(RS485 serial interface)
motor and/on inverter overheat-
ed or fault (if the "A" symbol flashes, it
means that there is a fault with pump 1;
if the "B" symbol flashes, it means that
there is a fault with pump 2)
42
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- try to keep the key on the remote control held
down again (also follow the instructions in the
relative chapter)
- add water until it covers the highest nozzles
on the backrest, so they are immersed and
keep the key held down once again
- within about 5 minutes from the appearance
of the warning (failure to do so will result in the
function being definitively reset) refill the tank
with the recommended liquid sanitiser (should
the function not start on its own, hold down
the relative key once again)
- check that the main switch is not off and/
or that the system is not faulty (contact your
trusted electrician)
- add water within about 5 minutes from the
appearance of the warning (the function will
resume automatically); where this is not the
case, the function will be definitively reset
- add the liquid within about 5 minutes from
the appearance of the warning (the function
will resume automatically); where this is not
the case, the function will be definitively reset
- contact an authorized Jacuzzi® service centre
- wait about half an hour and then try to restart
the pump; if this does not resolve the problem,
contact a Jacuzzi® Service Centre