Publicité
Instruction CF-RC Remote Controller
4. Mounting
The Remote Controller has been installed – g. 2
When the Remote Controller has been installed to the
Master Controller (see 2), it can be mounted on the wall by means of
the back plate/docking station
Remote Controller to a 230V power supply with the included trans-
former/power supply plug
Remote Controller is powered by two AA Alkaline 1.5V batteries.
• Before you place the back plate/docking station on the wall, verify the
transmission to the Master Controller from the desired location by car-
rying out a link test (see 3)
• Mount the back plate/docking station on the wall with the screws and
wall plugs
• Connect the docking station to a 230V power supply outlet by means
of the transformer/power supply plug
• Place the Remote Controller in the docking station
Note: To extend the transmission range of the CF2 system, up to three
Repeater Units can be installed in a chain – see g. 4
8
VI.UH.M2.52
. This makes it possible to connect the
. When it is not in the docking station, the
Produced by Danfoss Floor Heating Hydronics 09.2005
Publicité
