Publicité
Instruction CF-RC Remote Controller
5.4 Alarms
If an error occurs in the CF2 system, it is indicated by the Master Con-
troller and directly on the Remote Controller Display:
When the alarm is acknowledged with OK, the Buzzer of the Master
Controller will go O (if set to Sound On, see 5.3), and the CF2 system
will switch to Alarm status as indicated on the start-up screen:
This indication of Alarm on the Remote Controller and the indication
on the Master Controller will continue until the error that caused the
alarm has been xed.
VI.UH.M2.52
19
Produced by Danfoss Floor Heating Hydronics 09.2005
Publicité
