Publicité
Instruction CF-RC Remote Controller
6. Uninstallation
It is only possible to remove the Remote Controller from the CF2 sys-
tem by resetting the Master Controller to factory settings!
Resetting the Master Controller to factory settings – g. 3
• Disconnect the Master Controller from the 230V power supply until
the power Led
• At the same time, press and hold the menu selection button
OK button
, and the output selection button
• Reconnect the Master Controller to the 230V power supply and re-
lease the three buttons when the power LED
• All the output LEDs will go ON. The Master Controller is reset when all
output LEDs go OFF.
Note: Resetting the Master Controller also removes all Room Thermostats
etc.
VI.UH.M2.52
goes OFF.
Produced by Danfoss Floor Heating Hydronics 09.2005
, the
.
goes ON.
21
Publicité
