Télécharger Imprimer la page

Whirlpool SF378LEPS2 Guide D'utilisation Et D'entretien page 8

Publicité

ELECTRONICOVENCONTROLS
Style 1 - Electronic Oven Controls (on some models)
A
B
G
DE
The START or START/ENTER pad begins any oven function. If not
pressed within 5 seconds after pressing a function pad, the
"START?" indicator light will flash as a reminder. On some
models, "START?" will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed
function will be canceled.
F
G
H
/
J
K
A. Display
B. Timer
C. Clock
D. Auto clean
E. Oven light pad
(on some models)
F. Sequence programming
(on some models)
G. Oven settings
H. Warming drawer
(on some models)
I. Temperature
J. Timed cooking
(on some models)
K. Hour/minute
(on some models)
L. Start/control
lock
M. Cancel
Style2 - Electronic Oven Controls (on some models)
A
B
C D E
F
Bake
Broil
Clean
On
Delay
Door
Controls
Locked
Locked
r.... IIous oMII
S AR,
II00O4
......
BROIL
TIME
TIME
,J
K
J
/
H
SELF-CLEANING
OVEN
G
A. Oven display
G. Temperature/time
B. Clock
H. Cook time
C. Timer/cancel
I. Start time
D. Start/enter (control lock)
J. Custom broil
E. Auto clean
K. Bake
F. Off/cancel
M
When power is first supplied to the appliance, "PF" or a flashing
time will appear on the display. Press CANCEL or OFF/CANCEL
to clear "PF" or flashing time from the display.
If "PF" or flashing time appears, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer and Control Lock.
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or TEMP/
TIME "up" or "down" arrow pads to set the time of day,
including a.m. or p.m.
3. Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder, repeating each minute after the end-of-cycle
tones
Three tones
Invalid pad press
Four tones
End of cycle
Reminder
Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. "rEP OFF" or
"off" will appear in the display. Repeat to turn reminder tones
back on, and "rEP on" or "on" will appear in the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle
tones can be turned off.
8

Publicité

loading