Abicor Binzel EN 60 974-7 Mode D'emploi page 24

4 Putting into operation
4.5 Feeding in the wire
1 Torch neck
2 Clamping cap
3 Flat-head screw
Fig. 6 Feeding in the wire
EN - 10
NOTE
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.
1
7
4 Fixing plate
5 Potentiometer (optional)
6 Handle
NOTE
• Each time the wire is changed, make sure that the beginning of the wire is
free of burrs.
• Make sure that the wire feed roll complies with the diameter of the
inserted wire electrode.
 8.1 Replacing the wire feed roll on page EN-13
1 Insert the wire in the wire feeder as specified by the manufacturer.
2 Remove clamping cap (2) from handle (6) .
3 Swing out seat clamp (7) laterally.
4 Press the "Current-less wire feed" trigger at the wire feed unit until the wire
emerges from the contact tip.
5 Lock seat clamp (7) and attach clamping cap (2) .
The required contact pressure is pre-set via the knurled screw at the clamping
cap or is readjusted during the welding process.
2
3
4
6 5
7 Seat clamp
PP