Abicor Binzel EN 60 974-7 Mode D'emploi page 27

PP
8.1 Replacing the wire feed roll
8.2 Replacing liner in torch neck
1 Torch neck
2 Nut
3 Inlet nozzle
Fig. 7 Replacing liner in torch neck
 Fig. 6 Feeding in the wire on page EN-10
NOTE
• Required tools, crosstip screwdriver.
• Make sure that the wire feed roll complies with the diameter of the
inserted wire electrode.
1 Lift off clamping cap (2) and swing out seat clamp (7) .
2 Lift off the flat-head screw (3) using the crosstip screwdriver and lift it off
together with the fixing plate (4) .
3 Pull wire feed roll off the seat and replace it.
NOTE
• Ensure tight fit of the wire feed roll in the seat.
4 Swing in seat clamp (7) and attach clamping cap (2) .
1 2
8
4 Clamping cap
5 Counter nut M3
6 Seat clamp
1 Remove torch neck (1) from torch seat (7) by unscrewing the nut (2).
2 Lift off clamping cap (4) and swing out seat clamp (6) laterally.
3 Unscrew counter nut (5) from the inlet nozzle (3) .
8 Maintenance and cleaning
3
7
7
8
4
5
6
Torch seat
Liner (plastic)
EN - 13