Disassembly / Disposal; In The Event Of An Emergency; Warranty - Abicor Binzel ABIPLAS WELD 100W Mode D'emploi

12. Troubleshooting
(continuation)
13. Disassembly /
Disposal
14. In the event of
an emergency

15. Warranty

Problem Cause
Main arc does not • Connection between
ignite.
Torch body or current • Insufficient coolant flow.
lead overheated. • Welding current is too
• Coolant pipe or liquid-
• Plasma nozzle not
Pilot or main arc does not • Tungsten electrode
run straight.
• Plasma nozzle worn.
• Centring ceramic is
The welding torch is mainly made of plastics, stainless steel and non-ferrous metal
and must be disposed of in accordance with local environmental regulations.
The disposal of coolant is also subject to local regulations.
In the event of an emergency, the power supply must be switched off immediately.
For further action in such circumstances, consult the "power supply" operating
instructions.
The plasma welding torch ABIPLAS
BINZEL ® product.
Alexander BINZEL ® Schweisstechnik GmbH & Co. KG guarantees correct manufac-
ture and assumes a plant production and function warranty for this product upon
delivery in line with current state-of-the-art technology and the regulations in force.
The warranty covers manufacturing faults, but not damage resulting from natural
wear and tear, over-loading or improper use.
Parts subject to wear are not covered by the guarantee as a matter of principle.
The guarantee applies only when the plasma welding torch is operated with
genuine ABICOR BINZEL
®
Solution
– Connect ground cable.
work piece and the
welding machine is
interrupted
– Check the cooling unit.
– Reduce the welding
high.
– Remove cause of
cooled current cable
pinched or closed
– Tighten plasma nozzle.
tightened correctly.
– Re-sharpen tungsten
worn.
– Replace plasma
– Replace centring
missing or damaged.
® WELD 100W is an original ABICOR
replacement parts.
current.
pinching or replace
cable assembly.
electrode.
nozzle.
ceramic.