Publicité
by an authorized service center.
Always keep the plunge saw clean. Clean the
plunge saw after every use with a dry cloth or
compressed air. Do not use any aggressive
chemicals for cleaning.
CHANGE CARBON BRUSHES
The saw is equipped with self-isolating special
brushes. They are automatically isolated when
worn, and the tool stops. Check the carbon
brushes regularly. Replace the carbon brushes
with genuine spare parts if they are worn to
the wear limit (approx. 50% of the block).
Always replace the carbon brushes in pairs.
FINE ADJUSTMENT CUTTING PRECISION
The cutting precision for straight cuts (90° cuts)
is factory-set. Use a 3mm Allen key to adjust
the cutting precision at the bottom of the base
plate.
1. Use a setsquare to adjust the saw blade to
the 90° angle.
2. Swivel the plunge saw to the side and set
the cutting precision by means of the stud
screws.
The cutting precision for straight 45° miter cuts
is factory-set.
34
7061274 Ma # 1406-17.indd 34
All manuals and user guides at all-guides.com
1. Swivel the plunge saw to 45° position to set
2. Use a setsquare to check the angle.
3. Swivel the plunge saw to the side and set
TECHNICAL DATA
Mains power:
Power:
No load speed:
Miter setting:
Saw blade dimensions:
Weight:
Protecting class:
Max. cutting depth
with guide rail:
Max. cutting depth
without guide rail:
Max. cut with guide rail:
Max. cut without guide rail: 42 mm at 45°
Miter cut
Noise pressure level (L
Uncertainty
Sound power level (L
Uncertainty
Hand Arm Vibration
Hand grip
Hand Arm Vibration
Additional hand grip
Protecting rating
TM
the 45° mark arrow (see circle).
the cutting precision by means of the stud
screws.
) 83.8 dB(A),
pA
): 94.8 dB(A),
WA
230-240 V~
50 Hz
1400 W
2000-5300 min
-1
0° - 48°
165 x 2.2 x 20 mm
5.4 kg
II
54 mm at 90°
54 mm at 90°
38 mm at 45°
0 - 48°
K = 3 dB(A)
K = 3 dB(A)
3.976 m/s
2
K = 1.5 m/s
2
3.534 m/s
2
IP20
17-06-14 13:29
Publicité
