EQUATION Kaltar 500 Manuel D'utilisation page 124

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
Example : After several hours in manual mode with a set temperature of 20 ° C, I measure the temperature
in the room of 18 ° C. So I have to set a deviation of 18-20 = -2
FR
ES
Maximum temperature
The heater makes it possible to record a maximum temperature (between 19 ° C and 28 ° C) which cannot
PT
be exceeded during adjustments. By default, it is set to 28 ° C.
1 - Press the
IT
2 - Press
3 - Press
EL
4 - Set the new value with the
5 - Press
PL
Example : I want it not to be possible to set a setpoint temperature above 24 ° C
UA
>3s →
RO
Heating indicator in standby mode
After a few seconds without any action, the display of the control box turns off automatically, except the
EN
heating LED which lights up when the resistance is supplied.
It is possible to set the box so that this indicator goes off when the display of the box goes off .
1 - Press the
2 - Press
3 - Press
4 - Press
5 - Press
>3s →
Factory Settings
It is possible to reset the heater by erasing all the settings made (programs, calibration, maximum tempe-
rature, heating indicator). This function is useful in the event of programming errors.
1 - Press the
2 - Press
3 - Press
4 - Press
124
>3s →
and
keys at the same time for more than 3 seconds to display
to display
(Max Temperature)
,
fl ashes alternately with the currently set maximum temperature
and
to exit.
and
keys at the same time for more than 3 seconds to display
twice to display
(Heating Indicator)
,
fl ashes alternately with
to display
to exit.
and
keys at the same time for more than 3 seconds to display
3 times to display
(Factory Settings)
,
fl ashes alternately with
to display
keys (between 19 ° C and 28 ° C)

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières