Load Shedding; Advanced Functions - EQUATION Kaltar 500 Manuel D'utilisation

After 1 minute without any action, the module automatically exits the setting mode.
After a power cut, the settings are retained, a new setting of the day and time may be necessary
Lock / Unlock controls
The controls can be locked to prevent unintentional use, especially by children. To do this, simultaneously
press the and keys for more than 3 seconds. Proceed in the same way to unlock the controls.
→
Using a centralized manager (pilot wire)
The heater can follow the orders of a centralized manager by pilot wire link. Make sure the pilot wire is
connected to the black wire and that Manual mode is selected.
Comfort
Signal to transmit
Measurement
between pilot wire 0 volt
and neutral

Load shedding

The heater is compatible with a pilot wire load shedding system. Under no circumstances should a load
shedding by power cut-off be used, which could cause premature wear and damage to electronic boards
which would not be covered by the manufacturer's warranty. During periods of load shedding, the screen
goes to sleep. The device then returns to its original operating mode.

Advanced Functions

Press the and
vanced functions of the device.
Calibration
A diff erence between the setpoint temperature and the temperature actually measured in the room is
possible, it is generally due to the installation conditions of the heater (location, power / volume, insulation
of the room, ..). Calibration adapts the thermostat setting to actual room conditions.
1 - Place the heater in manual mode on 20 ° C and wait several hours
2 - Measure the room temperature using a thermometer and calculate the diff erence
deviation = measured temperature - setpoint temperature
3 - Press the and
4 - Press , fl ashes alternately with the currently set deviation
5 - Set the new value with the
6 - Press to exit.
→
> 3s
(locked
controls)
Eco Frost free
-115 volts
230 volts
négative
keys at the same time for more than 3 seconds to access the ad-
keys at the same time for more than 3 seconds to display
and keys (between -3 ° C and + 3 ° C)
→ →
> 3s
Heating shutdown -
Comfort -1 ° C
Load shedding
+ 115 volts 230 volts
positive during 3s
(unlocked
controls)
Comfort -2 ° C
5' 5'
3" 7"
230 volts
during 7s
> 3s
FR
ES
PT
IT
EL
PL
UA
RO
EN
123