Publicité
Basic Adjustment Settings
Power Control
Power Control provides convenient functions for power
saving.
Energy Save
Power consumption is saved by decreasing picture bright-
ness.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Save" or "Picture Off" ( /
Item
Standard
(factory default)
Save
Picture Off
5
Press HOME MENU to exit the menu.
• You can also select this function using the Home menu when the
input source is a PC.
No Signal off (AV mode only)
The system will be automatically placed into the standby
mode if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
Select "Enable" ( /
Item
Disable
(factory default) standby mode.
Enable
5
Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
programme finishes.
PDP-505XDE-Eng (33-35)
All manuals and user guides at all-guides.com
then ENTER).
then ENTER).
then ENTER).
Description
Does not decrease picture brightness.
Decreases picture brightness to save
power.
Deactivates the screen to save power. To
restore the screen display, press any
button other than i +/i – and
e.
This setting is not memorised by the
system.
then ENTER).
then ENTER).
then ENTER).
Description
Does not place the system into the
Places the system into the standby mode if
no signal is received for 15 minutes.
35
No Operation off (AV mode only)
The system will be automatically placed into the standby
mode when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Operation off" ( /
4
Select "Enable" ( /
then ENTER).
Item
Description
Disable
Does not place the system into the
(factory default) standby mode.
Enable
Places the system into the standby mode if
no operation is performed for three hours.
5
Press HOME MENU to exit the menu.
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby
mode when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Power Management" ( /
4
Select "Mode 1" or "Mode 2" ( /
Item
Description
Off
No power management
(factory default)
Mode1
• Places the system into the standby mode
when no signal is received from the
personal computer for eight minutes.
• Even when you start using the computer
and a signal is received again, the system
stays off.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or TV
unit.
Mode2
• Places the system into the standby mode
when no signal is received from the
personal computer for eight seconds.
• When you start using the computer and
a signal is input again, the system is
switched on.
• The system is switched on again by
pressing STANDBY/ON on the Plasma
Display or TV
unit.
5
Press HOME MENU to exit the menu.
04.6.15, 1:09 PM
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
on the remote control
on the remote control
09
35
En
Publicité
