Publicité
Presets
vTuner stations and Spotify albums can be stored as presets 1-10. This can
be done on the web page in "Streaming Audio" tab. When a preset is
saved, it will be selectable as an input either from the front panel, web
page, Lyngdorf Remote app or by remote control. A preset can be stored
by pressing a numeric key (1-6) on the remote control until that particular
preset selection is visible on front panel.
General setup
Power Management determines the stand-by setting of the TDAI-1120:
•
Deep Sleep (default) uses the lowest possible power consumption
•
Network Standby will keep the TDAI-1120 alert, and it will react to
commands over the networks
Auto off delay sets the idle time required for automatic shut-down of the
amplifier.
Trigger input function can be used to activate and deactivate the TDAI-
1120 through connection with a DC trigger signal from another device. If
you set it to a specific input, this input will be selected automatically upon
receiving a signal. Amp. Power Mode will start the TDAI-1120 on the input
last used.
Note: If the TDAI-1120 has been switched to another
input, the trigger command from the source connected
Remote control (optional accessory):
Disable the infrared remote control function, if the commands from other
equipment's remote controls are affecting the TDAI-1120.
Display settings will allow you to reduce the brightness level of the
display. You can activate a time-out, which will turn off the display with a
little delay after each operation.
Lyngdorf Audio TDAI-1120 – Owner's manual
will not turn off the amplifier!
ENG
DE
FR
39
Publicité
