Publicité
BOOSTER PUMP APPLICATION
To use this pump for pressure
STEP 1
boosting,
instructions
application, then connect the
pump to your water supply as per
the picture on right.
Use
STEP 2
shown) to connect pipes for an
easy service at a later date.
If your incoming pressure is
STEP 3
higher than 20 PSI, install a
pressure reducer (not shown)
between the ball valve #1 and the
pump, setted to 20 PSI. This will
prevent an excess of pressure on
the house distribution piping.
Intall a pressure gauge as per the
STEP 4
pictures on the right, to monitor
the pressure in piping.
Set the ball valves as per ''to
STEP 5
operate the pump'' picture. Open
the nearest faucet and connect
the pump to an electrical outlet.
When all the air will be remove
STEP 6
from the piping, close the faucet.
The pump will stop after 7 to 10
seconds. Then, it will turn on
when a faucet is open.
WARNING
In a booster pump application the
incoming pressure must never be
higher than 20 to 25 PSI.
NEVER RUN THE PUMP DRY
read
carefully
for
shallow
appropriate
union
the
well
(not
Minimum 3ft
length of 1''
pipe or 3ft of
1'' flexible hose.
Minimum 3ft
length of 1''
pipe or 3 ft of
1'' flexible pipe.
7
Publicité
