Publicité
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures:
Check with your local electrical and plumbing codes to
A
ensure you comply with the regulations. These codes
have been designed with your safety in mind. Be sure you
comply with them.
We recommend a separate circuit be lead from the home
B
electrical distribution panel properly protected with a fuse
or a circuit breaker. We also recommend that a ground
fault circuit be used. Consult a licensed electrician for
all wiring.
C
The ground terminal on the three prong plugs should
never be removed. They are supplied and designed
for your protection.
D
Never make adjustments to any electrical appliance or
product with the power connected. Do not only unscrew
the fuse or trip the breaker, remove the power plug
from the receptacle.
Material required for drilled well application
Shallow well pump installation
Desired length of polyethylene 1'' pipe, 100 PSI, CSA or UL approved, to link up
from pumping level to pump.
1 1'' foot valve (750756 or 750752P).
1 well seal, as per well casing diameter (750929 6'' x 1'').
1 1'' well seal elbow (750860).
2 1'' male adaptors (750865 or 750871).
8 1'' stainless steel clamps (750885).
Teflon tape.
1 1'' valve for your discharge line.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench adjustable wrench to tighten fittings, propane torch and welding material.
2
SAFETY INSTRUCTIONS :
(indoor use only)
Publicité
