Publicité
APPLICATION :
This pump is designed for shallow well
installation for water level up to 25 feet.
CAPACITY AT 20 PSI, express in US GPH
5'
900
10'
750
15'
640
20'
560
25'
475
Friction loss in
pipe not included.
We recommend that you install your pump in a clean and dry location
STEP 1
where there is adequate room for servicing at a later date. Protection
from freezing temperatures and good ventilation should be considered
as well, to provide the pump an environment for long life. Locating the
pump as close as possible to the water source will reduce friction losses
encountered in the suction pipe.
Friction losses in the suction pipe must be taken into consideration when
the horizontal offset is greater than 50 feet.The suction pipes should be
increased from 1'' to 1 1/4''. This will reduce friction losses and allow the
pump to give maximum performance.
Never run the pump dry. Damage to the seal may occur. Fill pump body
and suction pipe with water before turning on the power.
VERY IMPORTANT
Please be advised that the Fluomac Electronic unit is a state of the art product and will
give you years of trouble free service. However, if the unit cycles ''ON and OFF'', this
means there is a leakage in your plumbing. For example : A toilet leak, the leakage must
be repaired to maintain the system pressure.
Furthermore, if you are pumping water from a sand point or if you have indication that your
well may contain sand, a sand filter must be installed in the suction of the pump.
Sand will damage the unit, due to its abrasive nature and will void warranty. If you have any
questions concerning your pump, please contact us on our toll free number
1-800-361-1820 before returning the pump to the point of purchase.
The above conditions are not under warranty. The warranty covers manufacturing defects only.
THE RUN OF THE HORIZONTAL PIPE FROM THE TOP OF YOUR
WELL INTO THE HOUSE, WHERE YOUR PUMP WILL BE LOCATED,
MUST BE INSTALLED IN A TRENCH, BELOW THE FROST LEVEL OF
YOUR AREA.
US GPH
US GPH
US GPH
US GPH
US GPH
INSTALLATION STEPS
FEATURES :
Easy to prime stainless steel pump body.
Totally enclosed, fan-cooled motor, bearing
to bearing. Built for a continuous use.
Full-time connected run capacitor, to
eliminate starting wear vs regular motor.
Thermal and overload protection.
Noryl impeller, built-in injector.
3/4 HP, 115VAC, 60Hz, 7.5A
(15A when the pump starts).
3
Publicité
