Publicité
PLEASE, FOLLOW THESE STEPS TO EASILY PRIME YOUR PUMP
Connect your discharge line, using a ball
STEP 8
valve, as illustrated (Photo 1). Pipe size
should be 1'' for the first 3 feet with no
elbows or tees.
Fill the suction line with water and
STEP 9
connect it to suction inlet (Photo 1).
Remove the plug of the priming pipe
STEP 10
and fill the pump body with water
(Photo 1).
Screw the plug to the priming pipe
STEP 11
using teflon tape (Photo 2).
Connect the pump. The pump should
STEP 12
delivered water to the plumbing line
within 30 seconds. If not, unplug the
pump and repeat from step 10. In
accordance with the lenght of your
suction line, you may have to repeat
these steps a few times.
NOTE : After installation, if the pump is cycling ''ON-OFF'' and/or comes on when you are not
visibly using water, the pump is not defective. It means you have a leak on discharge side of the
pump. The leak must be localised and needs to be repaired. If you need assistance to determine
same, please call 1-800.361.1820. The pump is warrantied by the manufacturer and you must call
us to dertermine procedures. The pump cannot be returned to the point of purchase without our
prior consent.
6
PRIMING INSTRUCTIONS
STEP 10
STEP 9
STEP 11
STEP 12
STEP 8
Minimum 3ft
of 1'' pipe no
elbows or tees
or 3ft of 1''
flexible hose.
Publicité
