Publicité
Window Installation Kit
Exhaust hose
Unit adaptor
Window slider
adaptor
Type window installation
Hook
Hole Seat
Lower groove
adaptor
Bolts
Window slider A
Window slider B
Installation
NOTE: Once the Exhaust Hose assembly and Adjustable Window Slider are prepared, choose from one of
the following two installation methods.
Type 1: Hung Window or Sliding Window Installation(For some models)
Foam seal B
(Adhesive type-shorter)
1. Cut the adhesive foam seal A and B strips to the proper lengths, and attach them to the window sash
and frame as shown.
Exhaust hose
assembly
Make sure the adaptor
is inserted into the lower
groove of the air outlet.
Window slider C
Or
Foam seal A
(Adhesive type)
Step One: Preparing the Exhaust Hose assembly
Press the exhaust hose
into the window slider adaptor
and unit adaptor, clamp automatically by
elastic buckles of the adaptors.
Step Two: Install the Exhaust hose assembly to
the unit
Insert unit adaptor of the Exhaust hose assembly
into the lower groove of the air outlet of the unit
while the hook of the adaptor is aligned with the
hole seat of the air outlet and slide down the
Exhaust hose assembly along the arrow direction
for installation.
Step Three: Preparing the Adjustable Window
Slider
1. Depending on the size of your window, adjust
the size of the window slider.
2. If the length of the window requires two or three
window sliders, use the bolt(s) to fasten the
window sliders once they are adjusted to the
proper length.
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Page 15
Publicité
