DeWalt DW088 Traduction De La Notice D'instructions Originale page 20

English
Detector Operation (Fig. F)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button
3. Position the detector so that the sensor window
detector up or down within the approximate area of the beam, until you have centreed
the detector. For information about the display window indicators and the audible
signal indicators, refer to the table titled Indicators.
4. Use the marking notches
Above Grade
fast beep
Mounting on a Grade Rod (Fig. F, G)
1. To secure your detector to a grade rod, first attach the detector to the clamp by pushing
in on the clamp latch
detector until the latch
2. Open the jaws of the clamp by turning the clamp knob
3. Position the detector at the height needed and turn the clamp knob clockwise to
secure the clamp on the rod.
4. To make adjustments in height, slightly loosen the clamp, reposition and retighten.
Detector Cleaning and Storage
• Dirt and grease may be removed from the exterior of the detector using a cloth or soft,
non‑metallic brush.
• The D WALT digital laser detector is rain resistant but not immersible. Do not pour
e
water on the unit or submerge it under water.
18
to accurately mark the position of the laser beam.
20
INDICATORS
Slightly Above
Grade
fast beep
26 . Slide the tracks
29 on the clamp pops into the latch hole
.
21
25 is facing the laser beam. Move the
Slightly below
On Grade
steady tone slow beep
27 on the clamp around the rail
31 counterclockwise.
Grade Below Grade
slow beep
28
30 on the detector.
on the