DeWalt DW088 Traduction De La Notice D'instructions Originale page 17

Fitting the Tool to the Wall Mount (Fig. C2–C4)
The tool has been equipped with a wall mount
ceiling installation and other specialty leveling projects. The pivot bracket
to attach the tool to the wall mount.
• Align the magnets
• To remove the wall mount, pull the wall mount from the tool applying sufficient force.
To fit the wall mount to wall track, proceed as follows (Fig. C3):
• Open the clamp jaws
• Place the clamp jaw around the wall track and release the clamp to close the clamp
jaws shut on the track.
To mount the wall mount to a wall, proceed as follows (Fig. C4):
• Hold the tool at the desired position against the wall and mark the location of the
mounting hole on the wall.
• Drill a hole at the marked location.
• Insert a corresponding plug into the hole.
• Hold the tool in front of the plug.
• Turn a screw into the mounting hole
Adjusting the Tool
• To initiate the leveling procedure, switch on the tool. The level and/or plumb orientation
is correctly adjusted as long as the laser beams remain on.
• The laser beams start flashing to indicate that the tool has been set up at a slope that is
beyond the self‑leveling range of 4 °. Switch the tool off, re‑adjust the tool set‑up within
the self‑leveling range and switch the tool on again.
Aligning the Laser Line (Fig. D)
Align the laser line of either one of the laser beams with the position mark. Move the tool
as required.
OPERATION

WARNING! Do not place the laser in a position which may cause anyone to
intentionally or unintentionally stare into the laser beam. Serious eye injury may
result from staring at the beam.
with the metal plate on the wall mount
14
15 .
16
9 for mounting to wall track to aid in drop
.
English
8 has magnets
.
9
15