Publicité
3. INSTALLATION INSTRUCTIONS
Location
When selecting a location for your appliance you should make sure the floor is flat and firm, and the
room is well ventilated. An average ambient temperature must be observed. This temperature is
specific according to the climatic class of the device:
Climatic class
CC1
CC2
CC3
Your appliance is of climate class CC3 (maximum temperature and humidity are equal
to +35°C and 75% ambient humidity). This climatic class is indicated on the rating
label located inside your appliance (class 7).
•
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
•
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to form
quickly on the interior surface requiring more frequent defrosting of the unit.
•
Plug the unit into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
Wheels installation instructions
1
4
Maximum ambient
temperature
25°C
32°C
40°C
wheel
caster
2
5
29
Maximum ambient
humidity
60%
65%
75%
3
6
Publicité
