Publicité
3) COLOR
(AM/FM)
Allows you to change the display color of the LCD screen.
1. Turn on the unit while pressing the AM/FM key (10). The symbol (Or, Gr,
bL, CY, YE, PU, CL) corresponding to the current color flashes on the
display.
2. Use the s/t keys on the front panel or UP and DN on the microphone
to select the desired color.
(green),
(orange),
ou
(cyan light).
3.
Long press the: F (5) key to validate the selected color.
4) F - FREQUENCY BAND SELECTION
(Configuration: EU ; PL ; d ; EC ; U ; In)
The frequency bands must be chosen according to the country where you
are going to operate. Do not use another configuration. Some countries
require user's licence.
See the table on page 55.
How to proceed:
-
Switch off the transceiver
-
Turn on the power while pressing the F (5) key. «F» and the letter corre-
sponding to the configuration are blinking.
-
In order to change the configuration, use the s/t keys on the front
panel or UP and DN on the microphone.
-
When the configuration is selected, press on the F (5) key during 1 s.
«F» and the letter corresponding to the configuration are continuously
displayed. At this stage, confirm the selection by switching off then
switching on again the transceiver.
See tables on page 50 ~ 54.
5) UP/DN - ON/OFF
(F + EMG)
This function allows you to activate ou deactivate the UP/DN buttons of
your microphone.
Switch on the device by holding down the F (5) + EMG (6) keys.
-
y
: UP/DN function disabled
OF
(blue),
(cyan),
(yellow),
(F)
y
: function enabled
ON
6) PRESIDENT CHANNELS - ON/OFF
-
Switch off the device.
-
Hold down the EMG button and switch on the device.
PC OF appears on the display when the channels are deactivated
or PC On when they are activated.
See § PRESIDENT CHANNELS
7) MICROPHONE TYPE
(purple)
The set can be used with both a PRESIDENT EL electret and DY dynamic
6-pin microphone.
Switch on the unit by holding down the SCAN button (7) to change the
microphone type.
The default microphone type is EL (electret).
8) ACCESSORY VOLUME
This function controls the volume of the device and an accessory connected
to the 6-pin socket.
-
Switch on the device by pressing and holding the VOX buttons (9).
-
Use the s/t buttons on the front panel or UP and DN (4) on the micro-
phone to select a parameter to be reset:
00 - adjusts the volume of the internal loudspeaker using the VOL (1)
button.
01 - adjusts the volume of the accessory using the VOL (1) button.
02 - adjusts the volume of the internal speaker and the accessory using
the VOL (1) button.
The default value is 00.
8) RESET
(F + AM/FM)
Used to reset user-defined parameters and return to default values.
-
Switch on the device by pressing and holding the F (5) and AM/FM
(10) keys.
-
Use the s/t keys on the front panel or UP and DN (4) on the microphone
to select a parameter to be reset:
rS
AL : reset all parameters
rs
SC : SCAN SKIP reset
rs
: memory reset
MEM
-
Press the F button (5) for.1 second to confirm your choice.
35
(EMG)
page 32
(SCAN)
(VOX)
Publicité
