Publicité
3) DISPLAY
Multi-functions LCD display (backlight). It allows visualizing all functions:
Shows transmission
AM
AM mode selected
FM
FM mode selected
UK
Shows the England configuration (see table on page 50)
Function key activated (selection of the frequency bands)
DW
Dual Watch activated
SCN
Scan function activated
SCN
Scan function disabled
Key beep
BP
Roger beep
HI-CUT
HI-CUT filter activated
NRC
NRC filter activated
NB
NB filter activated
ANL
ANL filter activated (only in AM mode)
LOCAL
Automatic adjustment of RF GAIN activated
ASC
Automatic Squelch Control activated
VOX
VOX function activated
Memory function (input data, recall or delete) activated
MEM
EMG
Priority channel (emergency) 19 or 9 activated
Shows the channel number
Shows the selected configuration
4) CHANNEL SELECTOR: s and t keys on front panel and
«UP» and «DN» on the microphone
These keys allow to change the channel (up/down). A beep sounds each
time you change the channel if the KEY BEEP function is activated (see §
KEY BEEP page 34)
5) F - FREQUENCY BAND SELECTION ~ MEM ~ SCAN MEM ~
DIMMER
F - FREQUENCY BAND SELECTION
See § page 35.
MEM
(long press)
3 channels can be memorized with following parameters: AM (except
for EC configuration) or FM; LOCAL; NB/ANL; HICUT (and CEPT/ENG in the U
configuration)
To memorize:
-
Long press on MEM (5), «MEM» blinks.
-
Press during 1 s on M1 (9), M2 (8), M3 (7) or M4 (6). «MEM» is displayed
continuously. The channel has been memorized.
To recall a memory:
-
Long press on MEM (5), «MEM» blinks.
-
Short press on M1 (9), M2 (8), M3 (7) or M4 (6).
-
«MEM» is displayed continuously. The memorized channel is active.
To delete a memory:
rs
-
See § Reset
MEM
page 35
SCAN MEM
(long press only during SCAN function (7))
Memory Scan allows you to scan the stored channels and priority channels.
-
During SCAN (7), press and hold MEM (5) to access the MEMORY SCAN
function. See § SCAN page
DIMMER
(F + AM/FM)
Used to adjust the brightness of the backlight (from 1 to 9) or to deactivate
it (OF: no backlight).
1. Press the F button (5).
2. Press the AM/FM button (10). The current level flashes on the display.
3. Use the s/t buttons or the UP/DN button (4) on the microphone to
adjust the desired brightness level.
4. Press the PTT key (18) to confirm.
The default brightness level is: 5.
31
32
Publicité
