Publicité
highest mowing height.
3.
Adjust to a lower mowing height and
mow the lawn again. Repeat until the
grass is the required height.
NOTE:
•
Do not cut wet grass, it will fasten to the
underside of the deck and prevent the
ejector/catcher from working properly.
•
New and/or thick grass can require a
higher mowing height.
MAINTENANCE
WARNING!
Switch off the lawn mower, unplug the
plug, and wait until all moving parts have
completely stopped before inspection,
maintenance and/or cleaning.
•
Always allow the lawn mower to cool
before cleaning.
•
Clean the lawn mower with a soft brush.
Do not use water or detergents.
FIG. 10
•
Make sure that all the screw unions are
properly tightened to keep the lawn
mower in safe condition.
•
Check the catcher for wear or damage at
regular intervals.
•
Be careful to make sure your fingers do not
fasten between the blades and the mower
deck – risk of serious personal injury.
•
When working on the blades, pay
attention to the fact that the blades can
move even when the lawn mower is
switched off.
•
Replace damaged or worn parts. Only use
approved spare parts and accessories.
BLADES
•
The blades are sharp – wear safety gloves.
•
Avoid touching the edge – risk of cut injury.
•
Be careful when lifting or turning over the
lawn mower.
•
We recommend replacing the blades
every other year.
•
Replace the blade immediately if it is
damaged.
Replacing the blade
WARNING!
The lawn mower will vibrate excessively if
the blade is unbalanced, which can result in a
risk of personal injury.
1.
Switch off the lawn mower, unplug the
plug, and wait until all moving parts have
completely stopped before removing/
fitting the blades.
2.
Place the lawn mower on its side.
3.
Grip one end of the blade firmly. Wear
safety gloves.
4.
Undo the retaining screw.
5.
Remove the blade.
6.
Place the new blade over the guide pins.
7.
First put on the washer and then the nut
on the bolt.
8.
Tighten the nut.
FIG. 11
9.
Stand the lawn mower on its wheels again.
STORAGE
•
Switch off the lawn mower, pull out the plug,
wait until all moving parts have completely
stopped and allow it to cool before
transporting and/or putting into storage.
•
Clean all the parts on the lawn mower.
Empty and clean the grass catcher.
•
Store the lawn mower in a dry, cool and
well-ventilated place, out of the reach of
children. Store the lawn mower away from
corrosive substances, such as salt. Do not
store the lawn mower outdoors.
TRANSPORT
Secure the lawn mower so that it cannot move
or tip over when transporting it in a vehicle.
EN
7
Publicité
