Publicité
EN CFX2 28, CFX2 37, CFX2 45, CFX2 57
Problem
When operating the cooler from the
DC outlet: The ignition is on and the
cooler does not operate. The power
LED does not light up.
The display displays an error code and
the cooler does not cool (see
codes
on page 20).
Error codes
NOTE If one of the error codes E 02 to E 07 occurs, contact an authorized service agent.
Error code
E 01
E 02
E 03
E 04
E 05
E 06
E 07
12 Warranty
The statutory warranty period applies. If the product is defective, please contact the manufacturer's branch in your
country (see dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following documents when you send in the device:
• A copy of the receipt with purchasing date
20
Possible cause
The DC plug is not connected correct-
ly.
The DC socket is dirty. This leads to
poor electrical contact.
The DC plug fuse has blown.
The DC fuse inside the cooler has
blown.
The vehicle DC outlet fuse has blown.
The cooler has switched off due to an
Error
internal fault.
Description
Low voltage/overvoltage
Fan overcurrent
Compressor start failed
Compressor speed low
Controller overheated
NTC open circuit
NTC short circuit
Suggested remedy
3.
If necessarry, charge the starting
battery.
Follow the manufacturer's in-
structions.
Reconnect the DC plug.
Clean the DC outlet.
Follow the manufacturer's in-
structions.
Replace the DC plug fuse, see
chapter
Replacing the DC plug
fuse
on page 18.
Contact an authorized service
agent.
Replace the vehicle DC outlet
fuse.
Follow the manufacturer's in-
structions.
Contact an authorized service
agent.
Publicité
