Publicité
GB
► P. 3, item 1
1. Operating lever
2. Handle bar
3. Handle bar, bottom part
4. Protective flap
5. Battery cover
6. Levier for working depth adjustment
7. Bag for cuttings
8. Handle bar, middle part
9. Circuit breaker
10. Operating safety lock
► P. 3, item 2
11. Battery pack (not included in the scope of deliv-
ery)
12. Display for remaining capacity
13. Push button for capacity display
14. Locking button
15. Control lights
16. Battery charger (not included in the scope of
delivery)
What is included
• Instructions for use
• Lawn aerator/Scarifier
• Handle bar
• Handle bar, middle part (2×)
• Handle bar, bottom part (2×)
• Collection sack
• Working roller for aerating
• Working roller for de-thatching
• Bag with small parts
Fitting
Mounting the handle
Note: All mounting steps must be performed
on both sides.
► P. 4, item 3
– Position the bottom part of the handle bar (3) into
the locators on the product and tighten with
screws (17).
– Position the middle part of the handle bar (8) onto
the bottom part of the handle bar and push
through the carriage bolts (18).
– Position the toggle nuts (19) and tighten.
► P. 4, item 4
– Position the handle bar (2) onto the middle part of
the handle bar and push through the carriage
bolts (20).
– Position the toggle nuts (21) and tighten.
– Clip the cable into the cable clamps (22).
Mounting the collection box
► P. 5, item 5
– Pull the collecting bag (23) over the wire bar (24)
as shown.
– Slide the rubber lips (25) onto the wire bar (24)
and allow to engage.
30
Using for the first time
Charging the battery pack
Note: The device is operated with two 20 V
batteries. Use rechargeable batteries with
the same charge level and capacity for opti-
mum performance.
Note: Rechargeable battery and charger
are not part of the scope of delivery and are
available optionally from your dealer
(► Accessories – p. 33).
WARNING! Risk of injury! Comply with all
safety instructions when handling recharge-
able devices.
NOTICE! Risk of damage to the unit! Do
not allow the battery pack to deep discharge.
Note: The Li-Ion battery pack can be
charged at any time without affecting the life-
time of the unit. Interrupting the charging
process will not damage the battery pack.
• The battery pack must be charged prior to the first
start-up (charging time: ► Technical data –
p. 33).
► P. 5, item 6
– Press in the locking button (14) and remove the
battery from the device.
► P. 5, item 7
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
lights (15).
– Slot the battery pack into the device and make
sure it clicks into place correctly.
Checking the remaining capacity of the battery
– Press the button (13).
The remaining capacity of the battery is displayed by
the control lights (12).
Operation
Check before use!
DANGER! Danger of injury! Do not oper-
ate the machine unless you did not find any
faults. If a part has become defective, make
sure to replace it before you use the
machine again.
Check the safe condition of the machine:
– Check it for visual defects.
– Check that all parts of the machine have been
securely fitted.
Changing the working roller
DANGER! Danger of injury! Always dis-
connect the mains plug before all work on
the machine (ensure that there is no current
to the machine).
WARNING! Danger of injury! The working
roller's discs and tines are sharp. Wear
working gloves.
Publicité
