Publicité
CAUTION
– Indicates that failure to follow the instruction may cause body injury or property damage.
1. Do not install or use the product in wet places as steam room etc.
2. It is recommended to use water-proof electrical outlet which should be installed in a
place where is not easily to get wet.
3. This product should be used with 110V-120V, 60Hz electrical current only, load
current is at least 15A. Power plug must be equipped with ground fault circuit
interrupter or ground fault electrical leakage protector or similar high sensitive, rapid
type leakage switch (Rated sensitive current under 6mA).
4. When it thunders, it is strongly recommended to pull out the power plug.
5. Do not stand on ceramic toilet.
6. Ceramic toilet must install floor fixing bolts.
7. Do not stand on product unit, seat and lid.
8. Do not lean against the seat lid when using the product, to avoid damage.
9. This product is equipped with a soft-closing seat lid. Do not push the toilet seat
closed, or damage may occur.
10. Do not use caustic chemicals or scrubbing brushes to clean this product.
11. Exposure to direct sunlight is not allowed.
12. Only use tap water or potable water, as using other types of water may cause damage.
13. Do not connect water supply to heater outlet. Make sure inlet water temperature is
between 3~35°C/37.4~95°F.
14. When the room temperature is under zero degree, please drain the water tank, to
avoid freezing.
15. Raise room temperature to prevent the toilet from damage due to freezing.
16. When moving the product from a cold or wet environment to a normal room temperature, wait
2 hours until any condensation has fully evaporated. This will help prevent electrical short circuits.
17. When not using the product over three(3) days, drain the water out of the toilet and
pull the electrical plug from the wall outlet.
18. Stop using the product and shut off the power when product malfunctions. Call for
professional service.
19. For models with the foam shield function, please do not run the foam shield function without
the "foam agent", otherwise the service life of the foam shield may be shortened.
GROUNDING INSTRUCTIONS
This product should be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current. This
product is equipped with a cord having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed and grounded.
DANGER
– Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to
either flat blade terminal. The wire with insulation having an outer surface that is green with or
without yellow stripes is the grounding wire.
This product is factory equipped with a specific electric cord and plug to permit connection to
a proper electric circuit. Make sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this product. Do not modify the plug
provided — if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
If the product must be reconnected for use on a different type of electric circuit, the reconnection
should be made by qualified service personnel.
3
SAVE THESE INSTRUCTIONS
www.woodbridgebath.com
Publicité
