Télécharger Imprimer la page

Woodbridge EBT230 Guide D'installation Et De Maintenance page 17

Bidet de toilette électronique

Publicité

Power and water failure
Put around 2.1Gal (8L) water into a barrel
and flush the ceramic bowl.
Note: Avoid water spilling from the bowl.
Failure of remote control
1. Operate via knob on the main unit.
Knob
Battery replacement
Unplug the DC connector and remove the
battery box.
Install a new 9V alkaline battery.
Reconnect the battery box and put it back.
battery
Emergency troubleshooting
Note:
1. It is recommended to hire professional
personnel for this operation.
2. It is recommended to use 9V high-quality
dry battery, such as models 6LR61 or 6F22.
3. It is recommended to replace the battery
every two years, otherwise there may be a
risk of leakage.
Product unused for a while
When the product is left unused for a
long time, especially in cold weather,
it is highly recommended to drain the
water to prevent freezing.
To discharge water
1. Activate flushing, and then turn off angle
valve to stop water supply.
2. Unplug and cut off the electricity
3. Disconnect the hose from angle valve,
drain the water and reconnect.
4. For your safety, it is recommended to put
antifreeze into the remaining water in the
bowl.
* Please turn on power and water supply
when using again.
www.woodbridgebath.com
48.5mm
46.4mm
Note: Before water discharging, the
power must be cut off!
17.5mm
Male
buckle (+)
Female
buckle (-)
16

Publicité

loading