Télécharger Imprimer la page

Woodbridge EBT230 Guide D'installation Et De Maintenance page 21

Bidet de toilette électronique

Publicité

Problem
Night light
does not work
Foam shield has a
small amount of
Remote control
does not work
Stops in the
middle of use
Water comes out
unexpectedly from
the spray rod
When flushing, a
gurgling sound
can be heard once.
Caution
Cause
Night light function is "OFF".
Foam agent run out
The positive and negative
direction of the batteries is
incorrect.
Batteries have expired
The drying feature stops automatically after about 5 minutes of
continuous use.
The cleaning feature stops automatically after about 3 minutes of
continuous use.
The seat switch has difficulty detecting that the seat is in use.
Sit back on the toilet seat. If the user gets up slightly from the seat,
or sits forward on the seat, the seating switch may temporarily stop
detecting the user's presence.
When the user sits on the toilet seat, water will flow for several seconds
as it warms up. This is a normal function.
When the toilet is flushed with waste material, the sound produced is
due to air, waste, and water moving through the system. This is a n
ormal operation.
Please disconnect the power, wait for 30 seconds, then reconnect the
power to restore to factory settings.
If the problem still cannot be resolved, please disconnect the power
and contact service providers.
www.woodbridgebath.com
Troubleshooting guide
Solution
Set to "ON".
Add foam agent
Re-load batteries.
Load new batteries.
20

Publicité

loading