Publicité
Problem
Water supply hose is kinked.
Angle valve is not fully
Poor flushing
turned on.
Filter is dirty.
Angle valve is shut off.
A power outage occurred.
Not flushing
A water failure occurred.
Previous cycle not finished.
"Auto flushing" is set to "OFF"
Auto flushing
The seat switch will not turn
does not work
on unless the user is seated
properly.
"Auto pre-wetting" is set to
"OFF".
Auto pre-wetting
The seat switch will not turn
does not work
on unless the user is seated
properly.
The water temperature is not
set properly.
Low water
temperature
If the water supply or the bathroom temperature is low, the water
temperature may be cold when first sprayed.
The seat temperature is not
set properly.
In energy saving mode.
In standby mode.
Low seat
temperature
When seated, the temperature
will start to decrease after 10
minutes. Then, after an
additional 5 minutes, the toilet
seat heater will automatically
adjust to level 1 and remain at
that setting.
Low air
The air temperature is not
temperature
set properly.
Cause
Straighten the hose to remove the kink.
Turn on the angle valve fully.
Clean the filter.
Turn on the angle valve.
Use a bucket to manually flush.
Use a bucket to manually flush.
Wait until the previous cycle finishes
then flush.
Set to "ON".
Sit back on the toilet seat.
Set to "ON".
Sit back on the toilet seat.
Adjust the water temperature.
Reset the seat temperature.
Switch to functional mode and wait for
5+ minutes.
Switch to functional mode and wait for
5+ minutes.
Stand up from the seat and then sit
again.
Reset the air temperature.
www.woodbridgebath.com
Troubleshooting guide
Solution
18
Publicité
