KitchenAid KBFU271 Instructions D'installation Et Guide D'utilisation Et D'entretien page 10

Style 2
To Remove the Door:
1. Open the door to the full open position.
2. Locate and remove the 4 door hinge mounting screws.
To Replace the Door:
1. Slide the door hinges into the slots in the frame and push in
to seat hinges.
3=
A
A. Top screws (2 - underside of frame)
B. Bottom screws (2)
Pull the door away from the center to slide the door hinges
out of the slots in the frame.
2. Locate the 4 hinge screw mounting holes through the top and
bottom of the frame and replace the 4 screws. Do not tighten.
3. Check and adjust door then tighten the screws. See "Cabinet
Door Alignment."
4. Repeat steps 1 through 3 for the other door if necessary.
1=
2.
_ ,_ ....... ¢_i _ ,
Open cabinet door.
Use a short Phillips screwdriver or a 90 ° screwdriver with a
Phillips screw bit to loosen the 2 mounting screws on the
inner door panel.
4. Repeat steps 1 through 3 for the other door if necessary.
3=
A. Mounting screws
Position the condiment shelf so that the large ends of the
keyhole slots are over the 2 mounting screws.
B
A. Mounting screw in keyhole slot
B. Condiment sheff
4. Lower the condiment shelf until the 2 mounting screws are in
the narrow ends of the keyhole slots.
5. Tighten the screws.
10