ECOVACS WINBOT W2 PRO OMNI Manuel D'instructions page 27

App Connection
Before connection, make sure WINBOT and the mobile phone
meet the following requirements:
1. The Bluetooth of the mobile phone is turned on.
2. The WINBOT power switch has been turned on and the indicator
light has been lit.
3. Please pair WINBOT in ECOVACS HOME App instead of the phone
setting.
4. Co-frequency interference might occur between Bluetooth and Wi-
Fi. It is recommended to keep WINBOT close to the mobile phone
and distant from the Wi-Fi router during pairing.
5. If the connection failed, please try to disconnect other Bluetooth
devices, make sure WINBOT is not connected to other mobile phones,
and try again.
6. Bluetooth may be disconnected if WINBOT is too distant from the
phone. Try to reconnect at a short distance.
7. For using WINBOT, you need to allow ECOVACS HOME App to
obtain access to the location, Bluetooth, and mobile phone storage.
If the problems persist after trying the above methods, please contact
customer service.
Technical Specifications
Model
Rated Input 24V
Power Adaptor
100-240V~
Input
50-60Hz 2A
Station Dimensions (mm)
WINBOT Dimensions (mm)
Frequency Bands
Output power of the wireless module is less than 100 mW.
Note:
Technical and design specifications may be changed for
continues product improvement.
WG851-11
4A Rated Power 126W
BLJ96W240400P-US
Output 24V
312*215*327
271*271*77
2400-2483.5 MHz
4A
27 EN