ECOVACS WINBOT W2 PRO OMNI Manuel D'instructions page 18

Start Cleaning
2
Make sure Station and WINBOT is turned on.
1. Press and hold START button on WINBOT for 2 seconds to start the fan.
2. Place WINBOT's bottom close to the glass. WINBOT will automatically
attach itself and start cleaning.
Notes:
* Do not place WINBOT too close to the edge of the window. It is
recommended to keep a distance of at least 10cm from the edge of
the window.
* WINBOT is only suitable for flat surfaces without gaps.
* After the fan is started, do not bring small objects such as hair close
to the fan to prevent them from being sucked in and blocking the
fan.
* Before cleaning, please observe the area to attach WINBOT for any
small particles. If there are any, please remove them or switch to a
particle-free area to avoid scratching the glass.
2
EN 18
Swtich Modes
3
When WINBOT is working, you can switch cleaning modes by pressing
Mode Switching button on the Station. After switching the modes,
WINBOT will start the new cleaning mode immediately.
Note:
Press Mode Switching button to switch between Thorough Cleaning,
Fast Cleaning, and Edge Cleaning in sequence. To learn and use more
modes, refer to ECOVACS HOME App.
Select Cleaning Modes
Select the proper cleaning modes via buttons on the Station. If no
mode is selected, WINBOT follows the last remembered mode by
default.
Suggested Modes:
For moderately dirty interior windows, use Fast Cleaning.
For heavily soiled exterior windows, use Thorough Cleaning.
For detailed information on cleaning modes, please refer to the app.
* Edge Cleaning is not remembered. Thorough Cleaning is the default
cleaning mode.
Pause Operation and Move Station
4
Pause
Short press the Power button on the Station to pause WINBOT's
current work. Short press the Power button on the Station again to
have WINBOT resume and continue the unfinished cleaning task.
Move the Station:
During cleaning, if you need to relocate the station, firmly grip
the handle of the Station, lift it, and the Station's Suction Cup will
automatically unlock. If you release the handle and it drops back down,
the Station will automatically reattach to the surface and lock.
Note:
Before use, ensure there are no walls or other obstacles such as
furniture within a 10 cm radius of the Station. This allows the handle
to naturally drop to its lowest point. If the handle is obstructed from