Repeat steps 2,3 and 4 for the second wheel
base. Both wheel bases should be installed on
the utmost radiator fins to avoid tilting.
Operation
•
Operating voltage: 220-240V, ~50Hz, 1000W (model Heat Safe 1000 humid)
•
Heating:
1. Before operation, place the appliance in an upright position on a flat, stable and heat-resistant surface.
Make sure no flammable objects are near in a radius of 1 meter.
2. Turn the thermostat control to "min" and the power rotary switch to "0". Afterwards insert the power plug
into a wall socket.
3. At the power rotary switch, choose between "I" (low heating level), "II" (medium heating level) and "III"
(maximum heating level).
4. Please turn the thermostat control to "max". The lamp next to the thermostat control will light up. When
the room has reached a comfortable room temperature, turn the thermostat control counter-clockwise
until the lamp goes off. If you wish to increase the temperature, turn the control clockwise. If you wish
to decrease the temperature, turn the control counter-clockwise.
Please note: While turning the thermostat control, the lamp will only light up if the selected temperature
is higher than the room temperature.
5. To turn off the appliance, turn the power rotary switch to "0".
•
Humidifier:
1. Please turn off the appliance
and pull the humidifier out.
4. Please insert the
atomization nozzle into the
water tank.
All manuals and user guides at all-guides.com
1500W (model Heat Safe 1500 humid)
2000W (model Heat Safe 2000 humid)
2500W (model Heat Safe 2500 humid)
2. Please take out the
atomization nozzle.
5. Please insert the humidifier
back into the appliance.
After correct installation, the appliance should look
like the picture above. Now, turn the appliance back
on its feet. The appliance should have a stable stand
and, due to the wheels, be movable. Please remove
the carpet before using the appliance.
3. Please fill the water tank
6. Please press the on-/off-
with water.
switch to start.