Publicité
venting requirements
EN
2.8
top exit
WARNING
!
•
Failure to create a seal to the fi rebox with the exhaust collar assembly will cause the appliance to function
improperly and can cause injury or property damage.
note:
This appliance has been factory shipped as a top vent appliance.
Remove the safety barrier and glass door (see "safety barrier & door removal / installation" section).
A.
Remove the contents from the firebox and set aside.
B.
You will need the exhaust and air inlet collar.
To ease assembly, remove the 4 hex head screws,
C.
securing the deflector from inside the top front of the
firebox (Fig. 1). Set deflector aside.
Remove the 1 1/2" (38.1mm) thick batt of insulation and discard (Fig. 2).
D.
Place the 8" (203mm) intake collar and gasket onto the top of the appliance and secure using 4 screws
E.
(Fig. 2 and Fig. 3).
tip:
The manual baggie supplies the gasket and screws (packaged in another separate baggie).
INTAKE
COLLAR
GASKET
1 1/2" INSULATION BATT
22
W415-2920 / D-0 / 10.25.24
COLLET DU
PRISE D'AIR
note:
Top baffle must not be installed for top exit applications.
GASKET
OUTER
COVERPLATE
DEFLECTOR
DÉFLECTEUR
Exhaust Collar
HEAT
SHIELD
Fig. 2
Fig. 1
EXHAUST
FLUE COLLAR
Fig. 3
Publicité
