Publicité
Direct wire,
3-wire connection:
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
Direct wire cable must have 5 ft (1.52 m)
of extra length so dryer can be moved
if needed.
Strip 3
/
" (89 mm) of outer covering
1
2
from end of cable. Strip insulation back
1" (25 mm). If using 3-wire cable with
ground wire, cut bare wire even with outer
covering. Shape ends of wires into a hook
shape.
When connecting to the terminal block,
place the hooked end of the wire under the
screw of the terminal block (hook facing
right), squeeze hooked end together, and
tighten screw, as shown.
1. Loosen or remove center terminal
block screw (C).
2. Place the hooked end of the neutral wire
(white or center wire) of direct wire cable
(D) under the center screw of terminal
block (hook facing right). Squeeze
hooked end together. Tighten screw.
A
B
A. External ground conductor screw
B. Neutral ground wire
C. Center terminal block screw
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL listed strain relief
20
C
D
E
3. Place the hooked ends of the other
direct wire cable wires under the
outer terminal block screws (hooks
facing right). Squeeze hooked ends
together. Tighten screws.
4. Tighten strain relief screw.
5. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with holddown screw.
6. You have completed your electrical
connection. Now go to "Venting
Requirements."
Optional,
3-wire connection:
Use for direct wire or power supply
cord where local codes do not permit
connecting cabinet-ground conductor
to neutral wire.
1. Remove center terminal block screw (B).
2. Remove neutral ground wire (C) from
external ground conductor screw (A).
Connect neutral ground wire and the
neutral wire (white or center wire) of
power supply cord/cable (D) under
center terminal block screw. Tighten
screw.
3. Connect the other wires to outer terminal
block screws. Tighten screws.
4. Tighten strain relief screws.
5. Connect a separate copper ground
wire (F) from the external ground
conductor screw (A) to an adequate
ground.
6. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with holddown screw.
Publicité
