Publicité
Power supply cord strain relief:
Remove the screws from a 3/4" (19 mm)
■
UL listed strain relief (UL marking on
strain relief). Put the tabs of the two clamp
sections into the hole below the terminal
block opening so that one tab is pointing
up and the other is pointing down, and
hold in place.
Tighten strain relief screws enough to hold
the two clamp sections together.
Put power supply cord through the strain
■
relief. Be sure that the wire insulation on
the power supply cord is inside the strain
relief. The strain relief should have a tight
fit with the dryer cabinet and be in a
horizontal position. Do not further tighten
strain relief screws at this point.
Power supply cord,
4-wire connection:
IMPORTANT: A 4-wire connection is
required for mobile homes and where local
codes do not permit the use of 3-wire
connections.
16
A. Strain relief tab
A
pointing up
B. Hole below terminal
B
block opening
C. Clamp section
C
D. Strain relief tab
pointing down
D
B
A
C
D
A. 4-wire receptacle (NEMA type 14R-30R)
B. 4-prong plug
C. Ground prong
D. Neutral prong
E. Spade terminals with upturned ends
F. 3/4" (19 mm) UL listed strain relief
G. Ring terminals
1. Remove center terminal block screw (B).
2. Remove neutral ground wire (C) from
external ground conductor screw (A).
Connect neutral ground wire and
the neutral wire (white or center wire)
of power supply cord under center
terminal block screw (B). Tighten screw.
A
B
A. External ground conductor screw - Dotted line shows position
of NEUTRAL ground wire before being moved to center
terminal block screw.
B. Center terminal block screw
C. Neutral ground wire
D. Neutral wire (white or center wire)
E. 3/4" (19 mm) UL listed strain relief
F
G
E
C
D
E
Publicité
