Assembly; Operation - Wolf Garten HYBRID POWER 37 Mode D'emploi

Assembly

Fasten handle bars
A
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
Inlay the cable in the bend protection
When adjusting the handle height take care that the ca-
ble is not crimped
1. Fold the bottom part of the handle up and screw it tight with
the two hand wheels B
2. Set the handle to the desired height
3. Fold the upper part of the handle out and screw it tight with the
wing nuts D .

Operation

Contact key
F
1
Caution! Rotating blade
Before carrying out any adjustments:
Remove the contact key.
Do not touch rotating blades.
3
The hybrid mower is only powered with electricity if the
contact key is inserted.
Quick start (ready-to-use):
3
In mains power mode, the mower is ready for operation
within seconds.
1. Assemble machine and bag (see page 16).
2. Insert cable through the strain relief mechanism (see page 18).
3. Adjust cutting height (see page 16).
4. Attach bag (see page 17) or select mulching function (see page
17).
5. Switch on mower (see page 18).
General
Operating times
Please check noise abatement regulations prevailing in your
country.
Set cut height G
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
Switch off the motor and remove the contact key.
1. Pull the lever out.
2. Set the desired cutting height.
3. Press the lever back in.
16
B C D
A
.
C
.
C .
Mount the collecting bag
1. Place the chute (a) on the collecting bag flap (b).
2. Press the chute from behind onto the collecting bag flap. The
chute is ready for use as soon as it locks into place.
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 40-50 mm.
Overload protection
3
In case of overload or blocking, the motor shuts down
automatically!
Remove the contact key and eliminate the cause!
Overload: Cutting height is too low, or forward speed is
too fast
Blocking: Foreign object in cutting area (e.g. branches)
The machine can be switched on again after about 5
min.
Safety switch (in battery recess)
3
In order to avoid injury from electric shock, the battery
recess is equipped with a safety switch.
In mains power mode, the hybrid lawnmower is only
powered, if the safety switch is actuated.
The battery must be inserted in the battery recess.
Alternatively, you can insert a recess insert in the battery
recess. (e.g. while the battery is recharged with an
H
external charger).
Cut / Collect
Activate cut/collect function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Turn the switch to "CUT/COLLECT".
3. Hang up the collection bag if necessary.
4. Start the motor.
E
J
G