AGV Tourmodular Manuel D'utilisation page 20

11 CROWN PAD

11.1 REMOVAL

Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.

• Release the two snap buttons 1A by detaching them from the neck area 1B.

• Release the two cheek pads upper snap buttons 2A, to release the fabric headset ring 2B.

›

Release the five front plastic clips of the headset 3A from their seats 3B located in the

front area of the polystyrene shell.

11.2 INSTALLATION

Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.

• • Place the crown pad inside the helmet with the snap buttons positioned at the back.

Place the crown pad inside the helmet with the snap buttons positioned at the back.

• • Snap the two rear snap buttons

Snap the two rear snap buttons 1A 1A located in the neck area

Attach the two upper snap buttons of the pad 2A 2A, interposing the crown pad fabric rings

• • Attach the two upper snap buttons of the pad

› ›

Attach the five front plastic clips of the headset 3A 3A to their seats

Attach the five front plastic clips of the headset

1A 1A

located in the neck area 1B 1B. .

2B 2B

3A 3A

2B 2B

3A 3A

, interposing the crown pad fabric rings 2B 2B. .

to their seats 3B 3B. .

1B 1B

2A 2A

3B 3B