Publicité
1
2
2
1
5.5 MICRO-OPENING
In this position the visor is firmly closed pro-
viding maximum safety, but it creates a gap
of about 5mm to allow a moderate flow of air
inside the helmet.
Prerequisite: the visor is open.
›
Lower the visor until the engagement catch
1
engages the opening button
first click.
If necessary, facilitate this en-
gagement by pressing the visor
open button
Prerequisite: the visor is closed.
›
Press the opening button
movement, move the visor slightly upwards
until the engagement catch
visor to the first click.
5.6 CLOSURE ADJUSTMENT
It is possible to adjust the position of the hook-
ing cog, thus changing the pressure thereby
required to the button to open the visor.
Prerequisite: the visor is installed and open, and the
helmet is resting on a flat surface. Use a Torx
screwdriver.
1
• Loosen the screw
• Adjust the position of the engagement catch
2
as desired.
The farther back the catch is posi-
tioned, the more pressure is required
on the button to open the visor.
• Tighten the screw.
›
Make sure that the visor closes securely.
2
to the
2
lightly.
2
and, in a single
1
locks the
T7
®
.
EN
IT
FR
DE
ES
PT
DA
РУ
中文
中文
11
Publicité
