Publicité
Hella Gutmann
With
> Settings > Device > Region you can additionally set the region with
NOTICE
If the region set by you differs from the region in the HGS customer data (DE) then it may be possible that
not all functions are available.
8.6.5. Units of Measure
With
> Settings > Device > Units of measure you can select the required units of measure:
• Length unit
• Area
• Volume
• Temperature
• Unit of mass
• Speed
• Pressure
• Torque
• Flow rate
• Output
8.6.6. Automatic diagnostics
NOTICE
In order to increase the speed while reading out, you can select systems, which are probably not installed in
the vehicle. However, if there is a certain system installed in the vehicle or has been installed subsequently,
you should deactivate this function. All systems will be read out then. To increase the speed additionally you
can also optimize the communication protocols.
Proceed as follows to activate the function Automatic diagnostics:
1. Select
> Settings > Device > Automatic diagnostics.
2. Activate the check box Optimization of installation lists if necessary.
3. Activate the check box Optimization of installation lists if necessary.
8.7. Managing the HG-VCI S 20
With
> Settings > VCI you can call up information about the HG-VCI S20, such as:
mega macs S 20
.
Settings | 8.
101
Publicité
